淮北附近有没有服务

Hello, welcome to the stainless steel water tank manufacturer!

National hotline

eighteen billion six hundred and thirty-seven million three hundred and two thousand and ninety-nine

Your location: home page > News Center > Company news

What should be paid attention to in the installation and layout of stainless steel water tank?

Release date: April 29, 2020 Number of visits: four hundred and forty

  Stainless steel water tank According to different uses, stainless steel water tanks can be divided into fire water tanks, domestic water tanks, heat preservation water tanks and other types, and their shapes are mostly rectangular and round. Generally, they are composed of ventilation pipes, inlet pipes, outlet pipes, Manholes, floating ball valves, overflow pipes, drain pipes and other accessories


Here, the small five of Wuyi water tank mainly introduces the installation and layout of square stainless steel water tank.


1. Setting of water tank position


The location of the water tank shall be considered in combination with the building, structural conditions and convenient pipeline layout. It shall be set in a room with good ventilation and no freezing (the indoor low temperature shall not be lower than 5 ℃), the pipeline shall be as short as possible, and good lighting and anti mosquito conditions shall be provided. In order to prevent the water temperature rising caused by freezing or sunlight, the residual chlorine volatilization should be accelerated, and the water tanks set in the open air should be insulated.

 Stainless steel water tank

2. Water tank room setting


The clear height between water tanks is 1 m higher than that of water tanks, and the layout requirements are required. The load-bearing structure of water tanks shall be non combustible materials. The clear distance between the wall of high-level water tank and the wall between water tanks and other water tanks is the same as that of water storage tanks. The clear distance between the bottom of water tank and the ground panel between water tanks should not be less than 0.8 m when there is pipeline laying, so as to facilitate the installation and maintenance of pipelines. The setting height of water tank (based on the bottom plate surface) should be the same If the water pressure does not meet the user's requirements, the water pressure should be set in the high-rise pipe


3. Water tank spacing arrangement


For large public buildings and high-rise buildings, two water tanks should be set for water supply safety. When the water tanks are installed, they are supported by channel steel (I-beam) beams or reinforced concrete buttresses. In order to prevent corrosion between the bottom of the box and the supporting contact surface, asbestos rubber plate, rubber plate or plastic plate and other insulating materials should be padded between them.


Copyright? 2020 stainless steel manufacturer Engine technology network

Scan and consult wechat customer service
eighteen billion six hundred and thirty-seven million three hundred and two thousand and ninety-nine